Before using the toothed cutting tool, we need to adjust the parameters of the toothed cutting tool and the normal rotation axis. The detailed steps are as follows:
1. Adjusting the speed ratio difference between the tooth shaped tool supports is usually to ensure tension control between the front and rear blade supports. We need to adjust the blade mounting bracket as usual, which is usually manifested as fixture compensation.
2. The value of this blade has a certain range and is usually not too large. If the value is too large, it may damage the tensile spacing of the material.
3. Adjusting the tension of the receiving and discharging shafts, usually requires tension control based on the material being carried.
4. The setting of the indentation axis is opposite to the setting of the indentation axis. Usually, the discharge direction of the discharge axis is opposite to the rotation direction of the discharge axis. And the acceptance and discharge directions of the acceptance axis, as well as the rotation direction of the acceptance axis, are set to be the same.
5. After adjusting the above steps, we can proceed to the tool loading work. Before loading the tool, we need to compare the tools. Generally, please select the tool from the two tool clips of the circular tool.
