
There are two main methods for cutting circular knives: upper and lower circular knife cutting and circular knife kneading type cutting. Circular knife cutting is the main cutting method for cutting thick films, composite thick films, paper and other materials. It is recommended to use a circular knife for cutting materials with a film thickness of over 100um.
The upper and lower disc cutting blade methods are widely used, mainly including tangent cutting and non tangent cutting. Tangent cutting refers to the material being cut from the tangent direction of the upper and lower disc cutters. This type of cutting is more convenient for cutting, and the upper and lower disc cutters can easily adjust their orientation according to the cutting width requirements. Its disadvantage is that the material is prone to drift at the cutting point, so the accuracy is not high and is generally not necessary now. Non tangent cutting is when there is a certain angle between the material and the lower disc cutter, and the lower disc cutter falls to cut the material open. This cutting method can make the material less prone to drift and has high cutting accuracy. But adjusting the blade is not very convenient. When installing the disc cutter, the entire shaft must be removed. Round knife slitting is suitable for cutting thick composite films and paper.


The use of circular blade kneading type slitting is not very common in the industry. It mainly consists of a pneumatic slitting knife that synchronizes with the material speed and has a certain wrap angle with the material, a bottom roller, and convenient conditioning. This cutting method can cut thin plastic films as well as thick paper, non-woven fabrics, etc. It is a relatively convenient cutting method and also a development direction of cutting machine cutting methods.
When choosing cutting blades that are suitable for the machine, some users always objectively seek imported blades, but ignore the blades that should match their own model. Without distinguishing between the use of blades and one's own use, it is believed that only imported blades are good and useful. In fact, it is not the case. Whether imported or domestically produced, only blades that are conducive to product use are suitable.The advantages and disadvantages of cutting blades are relative, and the key to the cutting effect of the blade lies in its use. For example, improper use of imported blades will not yield good results, while reasonable use of domestic blades will also have a good effect.






