Dec 13, 2025 Leave a message

The Installation Of The Cutter For The Multi-column Packaging Machine Must Follow The Following Steps

I. Preparation before installation
1. Check the cutting tool: Ensure that the blade is not worn or chipped, and all components are intact.
2. Cleaning: Thoroughly clean the tool shank, the contact surface of the fixture, and the mounting holes to prevent foreign objects from affecting accuracy.

II. Installation Steps

1. Fixed rotating blade:Place the blade in a horizontal position and tighten the middle screw.
Gently push the fixed blade until there is a slight friction sound with the rotating blade, then fix the screws on both sides.

2. Adjust the gap:Tap the circular holes on both sides of the blade lightly with a copper hammer to ensure that the blade can pass through smoothly and produce a friction sound.
Test the single-layer film and make fine adjustments according to the actual effect until the film is cut smoothly.

3. Verticality Calibration:Use an indicator to measure the tool deviation within a 100mm stroke, which should not exceed 1mm.
Check the chip flow direction; if it deviates to one side, readjustment is required.

III. Notes

Lubrication: After installation, lubricating oil needs to be added to ensure the smooth operation of the cutter.

Safety: Cut off the power supply before operation. For professional issues, contact after-sales service.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry